This Delta Shaper is in excellent condition, and everything works. The shaper has a 220 volt single phase 3 HP motor. It has plenty of power to make raised panel doors, and the power feeder makes clean cuts with no burning while keeping your fingers attached. The fence is about the heaviest duty fence you can get and is adjustable on both sides. The oversize extra table just slides off when not needed but is so handy with large panels. The shaft is 3⁄4”, but you can buy 1⁄2” spindles or 1” if needed. They also make a collet that can use router bits. The shaper has two speeds with reverse. It also comes with a mobile base for easily moving it around your shop. Call with any any questions. Alternate phone number 435-681-0297