Putting feelers out for my jeep yj one ton project. It’s currently just a roller but is very close to being finished. ≈130k miles on the body and trans but everything else is new. As it sits now here’s a list of the work done. 1.D50 front axle regeared to 5.38 and all parts replaced, custom 3 link 0 miles on it 2. Sterling 10.5 rear, new wheel bearings and custom 4 link, has not been regeared yet 3. 15 gallon aluminum fuel tank with skid plate 4. Sitting on fox coil overs all around, 14 inch travel fronts and 12 inch travel on the rear 5. Transfer case has been rebuilt and a sye has been installed 6. Completely rewired bumper to bumper and a custom autometer electronic gauge cluster (done by a professional shop) 7. SBC swapped, I’ve replaced the motor with a freshly rebuilt on from xtreme performance, 0 miles on the motor and completely new accessory drive. Motor is good to run 8. I have all new calipers, rotors and pads for front and rear. 9. 40 inch Patagonia mile star XT, 0 miles on them 10. New fuel and brake lines 11. All fluids changed 12. 0 miles on pressure plate, clutch and throw out bearing