This Abrasive Jet Machining Center is in great condition.

The Y Axis Ball Screw is 55 inches long, the X Axis is 100 inches long.

This means you can fit a 4 by 8 sheet in this machine.

Pump is a 30 Horse Power / 44,000 PSI

Nozzle is a MAX Jet 5

New Parts Include:

Y Axis Ball Nut and Y Axis Ball Screw Support Bearing, X Axis Ball Screw Support Bearings, Timing Belts, New computer and panel mount Monitor, Cabinet Fan and Filter, Motor Contactor and Motor Bearings.

The Oil end of the has all new seals,

The wet end of the pump has been rebuilt with most of the major components replaced including 3 new plungers, dynamic seals, check valves and much more.

This machine comes with a large selection of spare parts.

35 to 40 AMP service is recommended. The motor full load amps are 28 at 480 volt.

This machine has and incredible success story and has earned an estimated 8.8 million dollars already. Who’s next?

Serious inquires only.