1978 Chevy 350 Engine Motor 76k Miles SBC 5.7 + Muncie SM465 4-Speed Transmission
8 Hours
26
1
$950.00
Description
Condition
Payment Types Accepted
Venmo
PayPalSelling the motor/trans from my 1978 Chevy Squarebody truck. Hear it run (in video).
Engine:
- 350 cubic inch small block (5.7L)
- Edelbrock aluminum intake manifold
- Edelbrock 4-barrel carburetor
- Mileage: 75,792
Includes factory cast iron exhaust manifolds, starter, alternator, pulleys, fan, valve covers, distributor, plug wires, and original radiator.
Transmission:
- Muncie SM465 4-Speed (3-speed plus "granny gear")
- Shifter
- Clutch
- Pressure Plate
The motor/trans will be pulled in the next couple of weeks. This is a low mileage combination. This is coming out of an old Colorado Highway Dept Truck (out of Walden, CO - Jackson County). I am replacing the motor/trans with newer units and getting this old vehicle back on the road.
Hopefully timing will work with pulling this combo and loading it within a few days while using the engine puller.
Feel free to text/call with questions.
Located in Murray, about 1.5 miles west of I-15 off of 5300 south.
You Might Also Like
1978 Chevy 350 Engine Motor 76k Miles SBC 5.7 + Muncie SM465 4-Speed Transmission
8 Hours
26
1
$950.00
Description
Condition
Payment Types Accepted
VenmoPayPalSelling the motor/trans from my 1978 Chevy Squarebody truck. Hear it run (in video).
Engine:
- 350 cubic inch small block (5.7L)
- Edelbrock aluminum intake manifold
- Edelbrock 4-barrel carburetor
- Mileage: 75,792
Includes factory cast iron exhaust manifolds, starter, alternator, pulleys, fan, valve covers, distributor, plug wires, and original radiator.
Transmission:
- Muncie SM465 4-Speed (3-speed plus "granny gear")
- Shifter
- Clutch
- Pressure Plate
The motor/trans will be pulled in the next couple of weeks. This is a low mileage combination. This is coming out of an old Colorado Highway Dept Truck (out of Walden, CO - Jackson County). I am replacing the motor/trans with newer units and getting this old vehicle back on the road.
Hopefully timing will work with pulling this combo and loading it within a few days while using the engine puller.
Feel free to text/call with questions.
Located in Murray, about 1.5 miles west of I-15 off of 5300 south.
You Might Also Like
