In great working condition. It was removed from the shop to install a different press.

It operates off 230V, 3 phase. Self contained hydraulics. No air over hydraulics. Pump, tank and all are on this.

Distance between the columns is 48" so you can press on large parts.

The bed is adjustable for height with a manual cable hoist. It uses 6 pins to lock the bed into position. Only 2 pins are shown in the pictures.

I planned to install a 120v motor on this with a smaller pump if I needed to, but as it turns out it's a little big for my small garage. It's roughly 7' wide, 8' tall.

It's not real heavy, but not very light. I'm guessing 1,000-1,200 lbs. It will take a forklift or crane to lift it up.

Text is best way to reach me.