Great condition, well taken care of. Lots of upgrades to make it a more relibable printer. Not in a rush to sell it. Selling because I’ve decided to go with a new printer. Printer has the newer 4.2.7 main board I believe.

Upgrades:\

• MicroSwiss NG direct drive extruder\
• 60W hot end heater\
• higher quality springs for bed leveling\
• CR touch\
• textured metal magnetic bed\
• smooth metal magnetic bed\
• additional magnet for magnetic bed\
• many brass nozzles of various sizes (large majority are 0.4mm)

Still have: \

• original glass bed\
• original Bowden extruder\
• cr touch brackets for alternative setups\
• additional heater wire\
• maintenance toolkit

For another $100 I’ll include a Raspberry Pi 4 (4gb, I believe). I’ve been running the printer with Klipper via the Raspberry Pi and have found it to be a better experience. It’ll still work just fine with the stock Ender software though!

Can include a partial roll of filament to get you started. Full rolls also available for purchase with the machine.