Front Axle Shaft w/ U-Joint - 4x4 - 36" Long Side - Unknown Application, See Measurements
5 Hours
3
0
$50.00
Jacob
Note: KSL, its service providers, and the seller receive data from this message. See our Privacy Notice and TOU for details.
Description
Condition
Payment Types Accepted
Venmo
CashApp
Zelle
ApplePayFront axle shaft assembly with U-joint, off a 4x4. There are no part numbers or markings anywhere on it, so I cannot tell you what it came off of. Measurements below. If you know axle shafts you will probably recognize it faster than I will.
Measurements:
Long section, spline tip to U-joint: about 36 inches
Short outer stub, seal face to spline tip: about 4-3/4 inches
Seal and slinger outer diameter: about 4 inches
Overall length: about 40 inches
Condition: serviceable U-joint with a grease fitting. Joint is tight with no play, bearing caps are unmarked. Splines are sharp and not rounded. Machined seal surface is clean. Some surface rust on the bar, cosmetic only.
SOLD AS-IS. Buyer verifies fitment. Happy to measure anything else or send more photos, and if you can identify it I will note it in the listing.
Asking $50 OBO. Local pickup in Price.
Also selling several other new auto parts, check my other listings.
You Might Also Like
Front Axle Shaft w/ U-Joint - 4x4 - 36" Long Side - Unknown Application, See Measurements
5 Hours
3
0
$50.00
Jacob
Note: KSL, its service providers, and the seller receive data from this message. See our Privacy Notice and TOU for details.
Description
Condition
Payment Types Accepted
VenmoCashAppZelleApplePayFront axle shaft assembly with U-joint, off a 4x4. There are no part numbers or markings anywhere on it, so I cannot tell you what it came off of. Measurements below. If you know axle shafts you will probably recognize it faster than I will.
Measurements:
Long section, spline tip to U-joint: about 36 inches
Short outer stub, seal face to spline tip: about 4-3/4 inches
Seal and slinger outer diameter: about 4 inches
Overall length: about 40 inches
Condition: serviceable U-joint with a grease fitting. Joint is tight with no play, bearing caps are unmarked. Splines are sharp and not rounded. Machined seal surface is clean. Some surface rust on the bar, cosmetic only.
SOLD AS-IS. Buyer verifies fitment. Happy to measure anything else or send more photos, and if you can identify it I will note it in the listing.
Asking $50 OBO. Local pickup in Price.
Also selling several other new auto parts, check my other listings.
You Might Also Like
