Sovol SV06 3D Printer + Filament Dryer — $200
23 Hours
16
0
$200.00
Description
Condition
Payment Types Accepted
ApplePay
Venmo
PayPalSelling my Sovol SV06 along with a Sovol dual-spool filament dryer.
The filament dryer has never actually been used. It powers on and is essentially new.
I bought the SV06 with a damaged/melted heating component and replaced it. The printer powers on, heats, moves and extrudes as it should. I've been able to get it printing, but I've never taken the time to fully dial in the calibration and bed adhesion enough to consistently complete prints.
I'm selling it because I simply don't have the time or interest to keep troubleshooting and learning the setup.
Because I haven't completed a full successful print, I'm selling it asnot fully tested/dialed-in. I don't know of a specific mechanical problem with it, but I also don't want to represent it as a perfectly calibrated, ready-to-print machine.
This would be a good setup for someone who wants an affordable entry into 3D printing and doesn't mind learning, calibrating and tinkering with the printer.
Includes:
-
Sovol SV06 3D printer
-
Sovol dual-spool filament dryer
-
Replaced heating component
-
Installed printed accessories/upgrades shown in photos
$200 for everything.
You Might Also Like
Sovol SV06 3D Printer + Filament Dryer — $200
23 Hours
16
0
$200.00
Description
Condition
Payment Types Accepted
ApplePayVenmoPayPalSelling my Sovol SV06 along with a Sovol dual-spool filament dryer.
The filament dryer has never actually been used. It powers on and is essentially new.
I bought the SV06 with a damaged/melted heating component and replaced it. The printer powers on, heats, moves and extrudes as it should. I've been able to get it printing, but I've never taken the time to fully dial in the calibration and bed adhesion enough to consistently complete prints.
I'm selling it because I simply don't have the time or interest to keep troubleshooting and learning the setup.
Because I haven't completed a full successful print, I'm selling it asnot fully tested/dialed-in. I don't know of a specific mechanical problem with it, but I also don't want to represent it as a perfectly calibrated, ready-to-print machine.
This would be a good setup for someone who wants an affordable entry into 3D printing and doesn't mind learning, calibrating and tinkering with the printer.
Includes:
-
Sovol SV06 3D printer
-
Sovol dual-spool filament dryer
-
Replaced heating component
-
Installed printed accessories/upgrades shown in photos
$200 for everything.
You Might Also Like
